CFG253 Performance Verification & Adjustment Procedures
Page 19 of 19 Procedure #: CP1005 Revision: A
REASSEMBLY
1. Disconnect any cables connected to the CFG253, turn off the POWER switch and
remove the power cord.
2. With the unit setting upside down on its top, place the handle upside down in
its opening in the case top and carefully slide the case bottom onto the unit. Be
sure that the front and back grooves line up and slip over the front and rear
panels.
3. Reinstall the two rear feet and screws plus the two front screws.
To Previous Page
Loading...
Need help?
General
