Status and Events
Table 3-5: Execution Error Messages (EXE Bit 4) (cont.)
Code Message
2220 Measurement error, No valid edge - No arm cross
2221 Measurement error, No valid edge - No trigger cross
2222 Measurement error, No valid edge - No second cross
2223
Measurement error, Waveform mismatch
2224 Measurement error, WAIT calculating
2225
Measurement error, No waveform to measure
2226
Measurement error, Null Waveform
2227
Measurement error, Positive and Negative Clipping
2228
Measurement error, Positive C lipping
2229
Measurement error, Negative C lipping
2230
Measurement error, High Ref < Low Ref
2231 Measurement error, No statistics available
2233
Requested waveform is temporarily unavailable
2235 Math error, invalid math description
2240 Invalid password
2241
Waveform requested is invalid
2244
Source waveform is not active
2245
Saveref error, selected channel is turned off
2250
Reference error, the reference waveform file is invalid
2253
Reference error, too many points received
2254
Reference error, too few points received
2259 File too big
2270 Alias error
2271 Alias syntax error
2273 Illegal alias label
2276 Alias expansion error
2277
Alias redefinition not allowed
2278
Alias header not found
2285
TekSecure(R) Pass
2286
TekSecure(R) Fail
2500
Setup error, file does not look like a setup fi le
2501
Setup warning, could not recall all values from external setup
2620
Mask error, too few points received
2760 Mark limit reached
2761 No mark present
2762
Search copy failed
MSO2000B, DPO2000B, MSO2000 and DPO2000 Series Oscilloscopes Programmer Manual 3-15
To Next Page
Loading...
Need help?
General
