Need help?Do you have a question about the Tektronix DPO2012 and is the answer not in the manual?
General| Bandwidth | 100 MHz |
|---|---|
| Channels | 2 |
| Sample Rate | 1 GS/s |
| Record Length | 1 M points |
| Vertical Resolution | 8 bits |
| Input Coupling | AC, DC, GND |
| Timebase Accuracy | ± 50 ppm |
| FFT | Yes |
| Power Supply | 100-240 VAC, 50/60 Hz |
| Display | 7-inch WVGA color LCD |
| Input Impedance | 1 MΩ ± 1% |
| Maximum Input Voltage | 300 V (DC + peak AC) |
| Trigger Types | Edge, Pulse Width, Video, Logic |
| Waveform Math | Add, Subtract, Multiply |
Precautions to prevent fire and personal injury when using the oscilloscope.
Details input voltage, power consumption, weight, and dimensions.
Explains how to connect different types of probes to the oscilloscope.
Steps for safely connecting the power cord and grounding the oscilloscope.
Steps to properly compensate a passive voltage probe for accurate measurements.
Steps to set up the oscilloscope to acquire signals using analog channels.
How to use the Autoset function to automatically configure oscilloscope settings.
How to set coupling, bandwidth, probe parameters, and offset for input channels.
How to take automatic measurements on acquired waveforms.
How to use on-screen markers (cursors) to take manual measurements.
Controls for efficiently working with long record length waveforms using zoom, pan, and marks.
To Next Page
