Locating Signals
Description. This is an I2S (Inter-IC sound) serial bus.
The clock rate is 2.5 M Hz.
CAN Bus
Board label. CAN_H, CAN_L
Connector grid location. B3, C1, D1
Description. These are the CAN (Controller Area N etwork) bus signals between two CAN transceivers.
The bit rate of the data packet is 500 kbps.
LIN Bus
Board label. LIN
Connector grid location. B1, B4
Description. This is the LIN (Local Interconnect Network) bus signal between two LIN transceivers.
The bus speed is 19.2 k baud. The signal contains a mix of version 1.x and 2.x frames.
RS232 U ART, Transmit
Board label. RS232_UART, RS23 2_TX
Demo 2 Board Instruction Manua l 117
To Next Page
Loading...
Need help?
General
