Tektronix FG 504 User Manual

Specification-FG 504
(SN
Β 040000 & UP)
Table 1-1 (cont)
C
haracteristic P erformance R equirement Supplemental Information
F
requency (cont)
R esolution
1 part in 10" of full-scale
setting usingthe FREQUENCY
VERNIER
control, as measured with α
frequency counter .
Stability Applies to calibrated portion of the
FREQUENCY
Hz dial only .
Time <-0 .05 ο/ο for 10 minutes
The instrument must b e at α
<-0 .1 ο/ο for
1 h our constant ambient temperature
-<0 .5 ο
/ο for 24 hours b etween 0°C and +50°C and
c hecked after α 1-hour
warmup
.
Temperature
See Dial Accuracy
Dial Calibration
1 to 40 Hz ( Χ MULTIPLIER
setting) calibrated ; 0 .1 to 1 Hz
( Χ MULTIPLIER setting) uncalibrated .
Dial Accuracy
FREQUENCY H z (START) W ithin 3 ο/ ο of full
scale from M easurements made at an ambient
d ial
0 .001 H z to 4 MHz . W ithin 6 ο/ ο of
temperature
between
+15o CC and +35'C
full scale from 4 MHz to
40 MHz . after 1 h our warmup .
STOP FREQuency d ial
W ithin 5 ο/ ο of the difference STOP FREQuency d ial is
b etween the start and stop uncalibrated on
the 10 6
frequencies plus the FREQUENCY
MULTIPLIER range .
Hz (START) dial
error .
M aximum F requency R anges for
M aximum to
Dial, Sweep
Frequency, and MULTIPLIER Minimum F req-
Voltage Controlled Setting ency R atios
F requency (VCF) M odes
106
500 :1
10
5 -10 1 ->1000 :1
10 1 , 1, 10 -1 , 10 - 1 ->100 :1
10
-s
40 :1
Internal Sweep L inear or L ogarithmic .
Accuracy
L imited by Start and Stop
F requency Specifications ; u se
external frequency
counter if
greater accuracy is required .
Sweep Duration
100 s to 0 .1 ms in six decades
(selected by SWEEP D
URATION
switch)
.
V ARiable control overlaps decades .
Stop F requency to
W ithin 2 ο/ο from 100 s to 1 ms
Swept Stop sweep duration .
F requency E rror
W ithin
10 ο
/ο from 1 ms
to
0 .1 ms
swee p duration .
LINear SWEEP 0 V to +10 V . Output impedance 1 k Ω .

Tektronix FG 504 Specifications

General

Brand	Tektronix
Model	FG 504
Category	Inverter
Language	English