Need help?Do you have a question about the Tektronix FG 504 and is the answer not in the manual?
Step-by-step guide for safely installing and removing the FG 504 from TM 500 series power modules.
Covers internal sweep, external inputs, tone bursts, filter testing, and pulse shaping capabilities.
Provides instructions for safely packing the instrument for transport or return for service.
Outlines checks to verify electrical performance against listed specifications, identifying calibration needs.
Detailed steps for calibrating instrument functions, including dial alignment, stability, and frequency accuracy.
Covers adjustments for +15V, -15V, ripple/noise, and voltage checks for instrument calibration.
Details adjustments for waveform symmetry on different dials and mechanical dial alignment checks.
Guides on calibrating frequency ranges, sweep accuracy, and timing for various operational modes.
Covers adjustments for amplitude flatness, AM balance, sine offset, and distortion for signal quality.
Recommends regular maintenance steps to improve instrument reliability and performance.
Provides resources like circuit diagrams, symbols, and troubleshooting flowcharts for fault diagnosis.
Explains procedures for ordering and replacing standard and special parts, including ordering information.
To Next Page
General