Tektronix FG 504 User Manual

Table 1-1 (cont)
Specification-FG 504 (SNΒ040000& UP)
REVNOV 1981

1-5
C
haracteristic P erformanceRequirement Supplemental Information
Out p ut W aveforms (cont)
Sine-Wave
Total H armonic
Typically _<1 ο/ο from 0 .001 H z to
Distortion 20 H z, measured un der the following
20 Hz to 40 kHz <-0 .5 ο / ο . con d itions : Temperature
+10°C
to
40kHz to 1 MHz Greatest
h armonic at least +35°C ambient terminated
30 dBdown . into 50 Ω ; zero offset ; <_30 dB
1 MHz to 40 MHz Greatest h armonic at least attenuation, and with
20 d8 down . FREQUENCY
H z (START) d ial set
between 4and 40 .
Sq uare-wave
RISE
AND F ALL TIMES _-6 ns 10 n s to 100 ms in 7 steps
Applies to p ulse waveforms also .
F IXED measured from 10% to 90%
Aberrations
_-5% ρ - ρ plus 30
mV into
50
Ω
load .
VARiable 10
ns
to 100 ms
in 7
steps .
P erio d of waveformmust exceed
M easured b etween the 10% and
combine d rise and
fall times
90% p oints of Am p litude ; accuracy
by %20 ο/ο .
within 30% . VARiable control h as
10 Χ range .
AM INPUT
Dc to 4 MHz 5 V ρ - ρ
signal p
ro
d
uces
100
ο
/ο When driven from α source
mo d ulation of α sine-wave carrier imped ance <_600 Ω .
with <_5% ο d istortion at 70 ο / ο
modulation .
4 MHz to 40 MHz ~10 ο
/ο d istortion at
65
ο/ο M odulating frequencies from 20 H z
mo d ulation . to 20 kHz . M odulation fre q uency
bandwi dth is do to 100
kHz . Α
mo
dulating source im pedance of
_<10 k Ω ensures proper
modulation an d d ivides the out-
put amplitude by 2 .
In p ut Im p edance _>1 ΜΩ .
E xternal TRIG/GATE/
Φ
L
OCK
Input
In p ut Im p edance >_10 k Ω .
Sensitivity _<1 V p- P .
M aximum Input Amplitude +20V .
TRIG
LEVEL -1 V to +10 V . F or triggering α single cycle
of generator waveform
.
M inimum P erio d 75 ns .

Tektronix FG 504 Specifications

General

Brand	Tektronix
Model	FG 504
Category	Inverter
Language	English