Tektronix MSO2000B Series

Commands Listed in Alphabetical Order
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger: A:BUS:B<x>:I2C:ADDRess:TYPe
{GENeralcall|STARtbyte|HS mode|EEPROM|USER}
SEARCH:SEARCH<x>:TRIGger: A:BUS:B<x>:I2C:ADDRess:TYPe?
Arguments
GENeralcall specifies the GENeralcall address type.
STARtbyte specifies the STARtbyte address type.
HSmode specifies the HSmode address type
EEPROM specifies the EEPROM address type.
USER specifies a user address.
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:I2C:ADDRess:VALue
Sets or returns the binary address s tring to be used for an I2C trigger searc h if
the search condition is ADDR or ADDRANDDATA.
SEARCH<x> is the search
number and
B<x> is the bus number.
Conditions
This command requires a DPO2EMBD application module.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger: A:BUS:B<x>:I2C:ADDRess:VALue <bin>
SEARCH:SEARCH<x>:TRIGger: A:BUS:B<x>:I2C:ADDRess:VALue?
Arguments
<bin> is the address in binary format.
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:I2C:CONDition
Sets or returns the search condition for an I2C trigger search. SEARCH<x> is the
search number and
B<x> is the bus number.
Conditions
This command requires a DPO2EMBD application module.
Group
Search
2-252 MSO2000B, DPO2000B, M SO2000 and DPO2000 Series Oscilloscopes Programmer Manual