Commands Listed in Alphabetical Order
Syntax
SEARCH:SEARCH
<x>:TRIGger:A:BUS:B<x>:I2C:C ONDition
{STARt|STOP|REPEATstart|AC KMISS|ADDRess|DATA|ADDRANDDATA}
SEARCH:SEARCH<x>:TRIGger:A :BUS:B<x>:I2C:CONDition?
Arguments
STARt specifies a search based on a start condition.
STOP specifies a search based on a stop condition.
REPEATstart specifies a search based on a repeat of start condition.
ACKMISS specifies a search based on a missing acknowledgement condition.
ADDRess specifies a search based on an address.
DATA specifies a search based on a data condition.
ADDRANDDATA specifies a search based on an address and data condition.
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:I2C:DATa:DIRection
Sets or returns the I2C search condition to be valid on a Read, Write, or Either
condition.
SEARCH<x> is the search number and B<x > is the bus number.
Conditions
This command requires a DPO2EMBD application module.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A :BUS:B<x>:I2C:DATa:DIRection
{READ|WRITE|NOCARE}
SEARCH:SEARCH<x>:TRIGger:A :BUS:B<x>:I2C:DATa:DIRection?
Arguments
READ specifies a read condition.
WRITE specifies a write condition.
NOCARE specifies either a read or write condition.
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:I2C:DATa:SIZe
Sets or returns the length of the data string in bytes to be used for an I2C trigger
search if the search condition is DATA or ADDRANDDATA.
SEARCH<x> is the
search number and
B<x> is the bus number.
Conditions
This command requires a DPO2EMBD application module.
MSO2000B, DPO2000B, MSO2000 and DPO2000 Series Oscilloscopes Programmer Manual 2-253
To Next Page
Loading...
