Tektronix MSO2000B Series Programmer's Manual

Commands Listed in Alphabetical Order
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger: A:LOGIc:INPut:CH<x> {HIGH |LOW|X}
SEARCH:SEARCH<x>:TRIGger: A:LOGIc:INPut:CH<x>?
Arguments
HIGH specifies the logic high.
LOW specifies the logic low.
X specifies a "don't car e" s tate.
SEARCH:SEARCH<x>:TRIGger:A:LOGIc:INPut:CLOCk:EDGE
Sets or returns whether the clock edge is a rising or falling for a logic search to
determine where to place a mark. <x> is the search number.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger: A:LOGIc:INPut:CLOCk:EDGE
{FALL|RISe|EITher}
SEARCH:SEARCH<x>:TRIGger: A:LOGIc:INPut:CLOCk:EDGE?
Arguments
RISe specifies a rising edge.
FALL specifies a falling edge.
EITher specifies either a falling or rising edge.
SEARCH:SEARCH<x>:TRIGger:A:LOGIc:INPut:CLOCk:SOUrce
Sets or returns the clock source definition for a logic trigger search. <x> is the
search number. If a clock source is defined, then the logic search is determined by
the state of the other inputs at the clock transition. If no clock source is defined,
then the logic search is determined only by the state of the inputs.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger: A:LOGIc:INPut:CLOCk:SOUrce
{CH<x>|MATH|REF|D<x>|NONe }
SEARCH:SEARCH<x>:TRIGger: A:LOGIc:INPut:CLOCk:SOUrce?
2-266 MSO2000B, DPO2000B, M SO2000 and DPO2000 Series Oscilloscopes Programmer Manual

Tektronix MSO2000B Series Specifications

General

Brand	Tektronix
Model	MSO2000B Series
Category	Test Equipment
Language	English