Tektronix MSO2000B Series

Commands Listed in Alphabetical Order
Group
Trigger
Syntax
TRIGger:A:BUS:B<x>:RS232C :RX:DATa:VALue
TRIGger:A:BUS:B<x>:RS232C :RX:DATa:VALue?
Arguments
<Qstring> is the binary data string to be used for the trigger.
TRIGger:A:BUS:B<x>:RS232C:TX:DATa:SIZe
Sets or returns the length of the data string for a RS232 trigger if the trigger
condition is TXDATA. Applies to bus <x>, where x is the bus number.
Conditions
This command requires a DPO2COMP application module.
Group
Trigger
Syntax
TRIGger:A:BUS:B<x>:RS232C :TX:DATa:SIZe <NR1>
TRIGger:A:BUS:B<x>:RS232C :TX:DATa:SIZe?
Arguments
<NR1> is the length of the data string in Bytes.
TRIGger:A:BUS:B<x>:RS232C:TX:DATa:VALue
Sets or returns the binary data string for a RS232 trigger if the condition involves
TX. Applies to bus <x>, where x is the bus number.
Conditions
This command requires a DPO2COMP application module.
Group
Trigger
Syntax
TRIGger:A:BUS:B<x>:RS232C :TX:DATa:VALue
TRIGger:A:BUS:B<x>:RS232C :TX:DATa:VALue?
Arguments
<Qstring> is the binary data string to be used for the trigger.
2-310 MSO2000B, DPO2000B, M SO2000 and DPO2000 Series Oscilloscopes Programmer Manual