Tektronix MSO2000B Series

Commands Listed in Alphabetical Order
Syntax
WFMOutpre:YOF
f?
Related Commands
DATa:SOUrce, WFMOutpre:BYT_Nr
Examples
WFMOUTPRE:YOFF? might return :WFMOUTP RE:YOFF -50.0000E+0 indicating
that the position indicator for the waveform was 50 digitizing levels (2 divisions)
below center screen (for 8-bit waveform data).
WFMOutpre:YUNit? (Query Only)
Returns the vertical units for the waveform specified by the DATa:SOUrce
command. The query command will time out and an e rror will be generated if the
waveform specified by DATa:SOUrce is not turned on.
Group
Waveform Transfer
Syntax
WFMOutpre:YUNit?
Related Commands
DATa:SOUrce
Examples
WFMOUTPRE:YUNIT? might return :WFMOUTPRE:YUNIT "dB" indicating that
the v ertical units for the waveform are measured in decibels.
WFMOutpre:YZEro? (Query Only)
Returns the vertical offset in units specified by WFMOutpre:YUNit? for the
waveform specified by the DATa:SOUrce command. The query command will
time out and an error will be generated if the waveform specified by DATa:SOUrce
is not turned on.
See the description of WFMInpre:YZEro to see how this offset is used to convert
waveform sample values to volts.
Group
Waveform Transfer
Syntax
WFMOutpre:YZEro?
Related Commands
DATa:SOUrce, WFMOutpre:YUNit?
MSO2000B, DPO2000B, MSO2000 and DPO2000 Series Oscilloscopes Programmer Manual 2-373