Tektronix MSO2012B Programmer's Manual

Commands Listed in Alphabetical Order
For SOUrce2: Se
ts or returns the waveform to measure "to" when taking a delay
measurement or phase measurement.
Group
Measurement
Syntax
MEASUrement:IMMed:SOUrce<x > {CH1|CH2|CH3|CH4|MATH}
MEASUrement:IMMed:SOUrce<x >?
Arguments
CH1–CH4 or MATH isthesourcewaveform.
MEASUrement:IMMed:TYPe
Sets or returns the immediate measurement type.
Group
Measurement
Syntax
MEASUrement:IMMed:TYPe
{AMPlitude|AREa|BURst|CARe a|CMEan|CRMs|DELay|FALL|FREQuency
|HIGH|LOW|MAXimum|MEAN|MIN Imum|NDUty|NEDGECount|NOVershoot
|NPULSECount|NWIdth|PEDGEC ount|PDUty
|PERIod|PHAse|PK2Pk|POVers hoot|PPULSECount|PWIdth|RISe|RMS}
MEASUrement:IMMed:TYPe?
Arguments
AMPlitude measures the amplitude of the selected waveform. In other words, it
measures the high value less the low value measured over the entire wa veform or
gated region. This measurement is available only on DPO models.
Amplitude = High – Low
AREa measures the voltage over time. The area is over the entire waveform or
gated region and is measured in volt-seconds. The area measured above the
ground is positive, while the area below ground is negative. This measurement is
available only o n DPO models.
BURst measures the duration of a burst. The measurement is made over the entire
waveform or gated region.
CARea (cycle area) measures the voltage over time. In other words, it measures, in
volt-seconds, the area over the first cycle in the waveform or the first cycle in the
gated region. The a rea m easured above the common reference point is positive,
while the area below the common reference point is negative. This measurement
is available on DPO and MSO models.
MSO2000B, DPO2000B, MSO2000 and DPO2000 Series Oscilloscopes Programmer Manual 2-191

Tektronix MSO2012B Specifications

General

Brand	Tektronix
Model	MSO2012B
Category	Test Equipment
Language	English