Commands Listed in Alphabetical Order
Arguments
CH1–CH4 is the c
hannel to use as the SPI SS source.
D0–D15 is the digital channel to use as the SPI SS source.
BUS:B<x>:ST
ATE
Sets or returns the on/off state of bus <x>, where x is the bus number.
Group
Bus
Syntax
BUS:B<x>:STATE {<NR1>|OFF|ON}
BUS:B<x>:STATE?
Related Commands
SELect:BUS<x>
Arguments
ON or <NR1> ≠ 0 turns on the bus.
OFF or <NR1> = 0 turns off the bus.
BUS:B<x>:TYPE
Sets or returns the bus type for <x>, where x is the bus number.
Group
Bus
Syntax
BUS:B<x>:TYPE {I2C|SPI|CAN|RS232C|PARa llel|LIN}
BUS:B<x>:TYPE
Arguments
I2C specifies the Inter-IC bus.
SPI spec ifies the Serial Peripheral Interface bus (not available on two-channel
models).
CAN specifies the Controller Area Network bus.
RS232C specifies the RS232C bus.
PARallel specifies the parallel bus.
LIN specifies the LIN bus.
MSO2000B, DPO2000B, MSO2000 and DPO2000 Series Oscilloscopes Programmer Manual 2-91
To Next Page
Loading...
Need help?
General
