Need help?Do you have a question about the Tektronix MSO4104 and is the answer not in the manual?
General| Bandwidth | 1 GHz |
|---|---|
| Sample Rate | 5 GS/s |
| Record Length | 10 Mpoints |
| Display Size | 10.4 inches |
| Display Type | TFT LCD |
| Input Voltage Range | ±40 V |
| Vertical Resolution | 8 bits |
| Vertical Sensitivity | 1 mV/div to 10 V/div |
| Power Supply | 100-240 VAC, 50/60 Hz |
| Input Impedance | 1 MΩ |
| Trigger Types | Edge |
| Interface | USB, LAN |
| Channels | 4 analog, 16 digital |
Defines terms and symbols used in the manual for safety.
Guides on unpacking and checking standard accessories before setting up.
Explains how to connect different types of probes to the oscilloscope.
Outlines the procedure for safely powering on the oscilloscope.
How to establish communication between the oscilloscope and a PC.
Guides on connecting and configuring analog channels for signal acquisition.
Explains how to automatically adjust settings for optimal signal display.
Guides on connecting and configuring digital channels for signal acquisition.
Guide to selecting various trigger types available on the oscilloscope.
How to set up triggers for various bus protocols.
How to use the oscilloscope to automatically measure signal parameters.
Uses on-screen markers for manual measurements on waveforms.
Breaks down signals into component frequencies for frequency domain analysis.
How to save and load waveform data to/from storage media.
Procedures for saving and loading instrument configurations.
Steps to print the oscilloscope screen image to a printer.
To Next Page