How to fix Tektronix Test Equipment that will not power on?
If your Tektronix Test Equipment instrument won't power on, first, make sure the power cord is properly plugged in. If it still fails to power on, the power supply may be faulty and need replacement. As a last resort, the micro-controller assembly might be defective and require replacement.
Why does my Tektronix Test Equipment have a blank or streaked flat-panel display?
If the flat-panel display on your Tektronix Test Equipment is blank or has streaks, the LCD screen or video circuitry is likely faulty and needs to be replaced.
What to do if Tektronix MSO46 Test Equipment powers on, but fans don't work?
If your Tektronix Test Equipment powers on but the fans aren't working, you should check the fan power cable to ensure it's properly connected, especially to the circuit board. If the cable is fine, the fan itself might be defective and need replacing. Alternatively, the power supply or point of load regulators could be faulty and require replacement.
Summary of safety precautions for operating the product.
Additional safety information required to safely perform service procedures.
Safety precautions and guidelines for using probes and test leads.
Precautions to avoid damage from electrostatic discharge during servicing.
Table listing common failure symptoms and their potential causes.
Provides a visual guide to diagnose faults step-by-step.
Explains the built-in diagnostic tests the instrument performs.
General| Bandwidth | 1 GHz |
|---|---|
| Analog Channels | 4 |
| Digital Channels | 16 |
| Form Factor | Benchtop |
| Vertical Sensitivity | 1 mV/div to 10 V/div |
| Probe Interface | TekVPI |
| Sample Rate | 6.25 GS/s |
| Vertical Resolution | 12 bits |
| Input Impedance | 1 MΩ |
| Trigger Types | Edge, Pulse Width, Runt, Logic, Setup/Hold, Rise/Fall Time, Video, Serial Packet, Parallel |
| Operating Temperature | 0 °C to +40 °C |
To Next Page