Tektronix MSO2024B Programmer's Manual

Getting Started
To set up e*Scop
e communications between your oscilloscope and a n etworked
computer:
1. With the DPO2C
ONN Connectivity Module installed, connect an Ethernet
cable from the back of the oscilloscope to the same network as your computer.
2. Power up you
r oscilloscope and test the network connection:
a. Push the Utility button, and then push Utility Page on the bottom menu.
b. Tu rn multipurpose knob a to select I/O, and then push Ethernet Network
Settings on the bottom menu.
c. Push Test Connection on the side menu. The button should say OK.
3. Next, find your oscilloscope’s IP address:
a. Push Change Instrument Settings on the s ide menu to display the
network parameters configured on your oscilloscope.
b. Note down the Instrument IP address.
1-8 MSO2000B, DPO2000B, MSO2000 and DPO2000 Series Oscilloscopes Programmer Manual

Tektronix MSO2024B Specifications

General

Brand	Tektronix
Model	MSO2024B
Category	Test Equipment
Language	English