Commands Listed in Alphabetical Order
SEARCH:SEARCH
1:TRIGGER:A:BUS:B1:LIN:DATA: SIZE?
might return
SEARCH:SEARCH1:TRIGGER:A:B US:B1:LIN:DATA:SIZE 1 indicating that
the LIN data size is 1 byte.
SEARCH:SEAR
CH<x>:TRIGger:A:BUS:B<x>:LIN:DATa:VALue
Sets or returns the binary data string used for a LIN search if the search condition
is ID or IDANDDATA.
Conditions
This command requires a DPO2AUTO applic ation module.
Group
Bus
Syntax
SEARCH:SEARCH<x>:TRIGger:A :BUS:B<x>:LIN:DATa:VALue <QString>
SEARCH:SEARCH<x>:TRIGger:A :BUS:B<x>:LIN:DATa:VALue?
Arguments
<QString> is the binary data string for the search.
Examples
SEARCH:SEARCH1:TRIGGER:A:B US:B1:LIN:DATA:VALUE? might return
SEARCH:SEARCH1:TRIGGER:A:B US:B1:LIN:DATA:VALUE "XXX XXXXX"
indicating that the data value is don't care.
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:LIN:ERRTYPE
Sets or returns the error type used for a LIN Search.
Conditions
This command requires a DPO2AUTO applic ation module.
Group
Bus
Syntax
SEARCH:SEARCH<x>:TRIGger:A :BUS:B<x>:LIN:ERRTYPE
{SYNC|PARity|CHecksum}
SEARCH:SEARCH<x>:TRIGger:A :BUS:B<x>:LIN:ERRTYPE?
Arguments
SYNC specifies a sync error type.
PARity specifies a parity error type.
CHecksum specifies a checksum error type.
MSO2000B, DPO2000B, MSO2000 and DPO2000 Series Oscilloscopes Programmer Manual 2-257
To Next Page
Loading...
Need help?
General
