Tektronix MSO2024B Programmer's Manual

Commands Listed in Alphabetical Order
TRIGger:A:SE
THold:HOLDTime
Sets or returns the hold time for setup and hold violation triggering.
Group
Trigger
Syntax
TRIGger:A:SETHold:HOLDTime <NR3>
TRIGger:A:SETHold:HOLDTime ?
Arguments
<NR3> specifies the hold time setting in seconds. Positive values for hold time
occur after the clock edge. Negative values occur before the clock edge.
Examples
TRIGGER:A:SETHOLD:HOLDTIME 3.0E-3 sets the hold time for the setup and
hold trigger to 3 ms.
TRIGGER:A:SETHOLD:HOLDTIME ? might return
:TRIGGER:A:SETHOLD:HOLDTIM E 2.0000E-09 indicating that the current
hold time for the setup and hold trigger is 2 ns.
TRIGger:A:SETHold:SETTime
Sets or returns the setup time for se tup and hold violation triggering.
Group
Trigger
Syntax
TRIGger:A:SETHold:SETTime <NR3>
TRIGger:A:SETHold:SETTime?
Arguments
<NR3> specifies the setup time for setup and hold violation triggering.
Examples
TRIGGER:A:SETHOLD:SETTIME 3.0E-6 specifies that the current setup time for
setup and hold trigger is 3 µs.
TRIGGER:A:SETHOLD:SETTIME? might return
:TRIGGER:A:LOGIC:SETHOLD:S ETTIME 2.0000E-09 indicating that the
current setup time for setup and hold trigger is 2 ns.
TRIGger:A:SETHold:THReshold:CH<x>
Sets or queries the threshold for the channel specified by x. Affects all trigger
types using the channel.
MSO2000B, DPO2000B, MSO2000 and DPO2000 Series Oscilloscopes Programmer Manual 2-337

Tektronix MSO2024B Specifications

General

Brand	Tektronix
Model	MSO2024B
Category	Test Equipment
Language	English