Commands Listed in Alphabetical Order
Arguments
CH1–CH4 specifi
es the analog channel to use as the I2C SDATA source.
D0–D15 specifies the digital channel to use as the I2C SDATA source.
BUS:B<x>:LABel
Sets or returns the waveform label for bus < x>, where x is the bus number
1 through 4.
Group
Bus
Syntax
BUS:B<x>:LABel <Qstring>
BUS:B<x>:LABel?
Arguments
<Qstring> is an alpha-numeric string of text, enclosed in quotes, that contains
the text label information for bus <x>. The text string is limited to 30 characters.
BUS:B<x>:LIN:BITRate
Sets or returns the bit rate for L IN.
Conditions
This command requires a DPO2AUTO applic ation module.
Group
Bus
Syntax
BUS:B<x>:LIN:BITRate <NR1>
BUS:B<x>:LIN:BITRate?
Arguments
<NR1> is the LIN bit rate.
Examples
BUS:B1:LIN:BITRATE 9600 sets the bit rate 9600.
BUS:B1:LIN:BITRATE? might return BUS:B1:LIN:BITRATE 2400 indicating
that the bit rate is set to 2400.
BUS:B<x>:LIN:IDFORmat
Sets or returns the LIN ID format.
MSO2000B, DPO2000B, MSO2000 and DPO2000 Series Oscilloscopes Programmer Manual 2-77
To Next Page
Loading...
Need help?
General
