Installation Instructions
4 SPG600 & SPG300 Sync Pulse Generators Upgrade Kit
7. SPG300: Remove the protective backing from the label marked “SPG3UP 01”
and apply it to the bottom of the instrument, just beside the serial number label.
SPG600: Remove the protective backing from the label marked “SPG6UP 01”
and apply it to the right side of the instrument, just under the serial number
label.
Installing the 4-Channel Analog Video Outputs Board (SPG6UP 02)
Perform the following procedure to install the 4-channel analog outputs board into
your SPG600:
1. Disconnect all external cables and the power cord from the SPG600 rear panel.
2. Use a screw driver with a #2 Phillips tip to remove the sixteen screws securing
the top cover to the chassis and remove the cover. See Figure 1.
WARNING. Disconnect the power cord from the line voltage source before
installing this option. Failure to do so could cause serious injury or death.
To Next Page
Loading...
Need help?
General
