Important safety information
This manual contains information and warnings that must be followed by the user
for safe operation and to keep the product in a safe condition.
To safely perform service on this product, additional information is provided at
the end of this section. (See page 4, Service safety summary.)
General safety summary
Use the produc t only as specified. Review the following safety precautions to
avoid injury and prevent damage to this product or any products connected to it.
Carefully read all instructions. Retain these instructions for future reference.
TCPA300/400 only: This product shall be used in accordance with local and
national codes.
For correct and safe operation of the product, it is essential that you follow
generally accepted safety procedures in addition to the safety precautions specified
in this manual.
The product is designed to be used by trained personnel only.
Only qualified personnel who are aware of the hazards involved should remove
the cover for repair, maintenance, or adjustment.
Before use, always check the product with a known source to be sure it is
operating correctly.
This product is not intended for detection of hazardous voltages.
Use personal protective equipment to prevent shock and arc blast injury where
hazardous live conductors are exposed.
While using this product, you may need to a ccess other parts of a larger system.
Read the s afety sections of the other component manuals for warnings and
cautions related to operating the system.
When incorporating this equipment into a system, the safety of that system is the
responsibility of the assembler of the system.
To avoid fire or
personal injury
Use proper power cord. TCPA300/400 only: Use only the power cord specified
for this product and certified for t he country of use.
Do not use the provided power cord for other products.
Ground the product. TCPA300/400 only: This product is grounded through the
grounding conductor of the power cord. To avoid electric shock, the grounding
conductor must be connected to earth ground. Before making connections to the
input or output terminals of the product, make sure that the product is properly
grounded.
Amplifiers and Current Probes Compliance and Safety Instructions 1
To Next Page
Loading...
Need help?
General
