TDS 500D, TDS 600B, & TDS 700D User Manual
3–197
Determining Status and Accessing Help
The TDS Oscilloscope can display the status of its internal systems. It also
provides an on-line help system. This section describes how to use the following
two features:
Status which displays a snapshot of system, display, trigger, waveform, and
I/O settings
Help which displays a screen of brief information about each oscilloscope
control when that control is operated
Displaying Status
To display the status of the internal systems, perform the following steps:
1. Press SHIFT STATUS ➞ Status (main).
2. Select a status snapshot from the side menu:
System displays information about the Horizontal, Zoom, Acquisition, Measure,
and Hardcopy systems. (See Figure 3–89.) This display also tells you the
firmware version.
Display provides parameter information about the display and color systems.
Trigger displays parameter information about the triggers.
Waveforms displays information about waveforms, including live, math, and
reference waveforms.
I/O displays information about the I/O port(s).
Histo/Masks displays information about histograms and masks.
Recalled Image Histogram displays the vertical and horizontal status when the
image histogram was saved. Status is only displayed if a Recall to Image
Histogram has been done since the oscilloscope was powered up.
To Next Page
Loading...
Need help?
General
