Tektronix TG8000 Declassification And Security Instructions

Clear and sanitize procedures
Table 3: Nonvol
atile memory devices for the GPS7 module
Type and
minimum size Function
May
contain
user
data
1
Data input
method Location To clear To sanitize
Flash memory
4MX8
Configuration of
FPGA
No Written by
processor
system from
TG8000 main
board
U0331 None
N/A
No customer
information is
stored in this
flash memory
Flash memory
4MX8
Calibration for the
module
Stores leap
second
information
Yes. The
values are
afunction
of how
the user
calibrates
the module
and when
it was last
receiving
the GPS
signal
Stored during
calibration
Stores leap
second
information
obtained by
satellite
U0332 Manually calibrate the
module back to the
factory default values
Allow the module
to receive satellite
information for
30 minutes to update
the leap second field
Remove and
destroy the
memory device
or destroy the
entire board
Flash memory
4MX8
unused No None U0741 None None
GPS receiver
assembly
Calculates timing
and position
information
Yes if
operated in
fixed mode
Location is
stored when
operated in
fixed mode
Mounts above the main
module board and
connects to J12 with
a ribbon cable, and to the
antenna connector on the
rear panel
Save a position from a
location different from
the one that was last
saved. This will erase
the previous position
and save the new one
Remove and
destroy the
module or
destroy the entire
board
1
Durin
g normal instrument operation.
4 TG8000 Declassification and Security Instructions

Tektronix TG8000 Specifications

General

Brand	Tektronix
Model	TG8000
Category	Portable Generator
Language	English