Tektronix TG8000 Declassification And Security Instructions

Troubleshooting
To recov er from clearing
or removing memory from
the mainframe
Perform the fol
lowing procedure to recover a module:
1. Power on the instrument with a GPS7 module installed.
2. Calibrate the mainframe oscillator oven as instructed in the TG8000
Multiformat Test Signal Generator User Manual (Tektronix part number
071-3036-X
X; 071-3037-XX, Japanese; 071-03038-XX Russian).
3. Configure the network parameters for the instrument as instructed in the
TG8000 Mult
iformat Test Signal G enerator User Manual (Tektronix part
number 071-3036-XX; 071-3037-XX, Japanese; 071-03038-XX Russian).
4. If you back
ed up the presets and user data files onto a USB drive before you
removed the mainframe memory, restore the presets or user data files as
described below:
a. Connect the USB drive to the TG8000 generator that you used to back up
the presets or user data files.
b. Press the MODULE button to select TG8000 : PRESET.
c. Press t
he up (▲)ordown(▼) arrow button to select TG8000 :
UTILITY, and then press the ENTER button.
d. Press
the up (▲)ordown(▼) arrow button to select TG8000 : UTILITY
:USB(status).
e. Ver i
fy that the USB status is Mounted.
f. If the status is Not Mounted, press the ENTER button to m ount the USB
dri
ve.
g. Press the up (▲)ordown(▼) arrow button to select TG8000 : UTILITY
:B
ACKUP/RESTORE.
h. Press the left (◄)orright(►)arrowbuttontoselectRestore Presets
fr
om USB or Restore All User Data from USB.
i.
Press the ENTER button to start the selected restore operation.
j. A warning message is displayed asking you to verify the operation. Press
the ENTER button to proceed or press the BACK buttontocancelthe
operation.
k. During the first s tage of the copy process, the display shows the names
of the files as they are copied. Depending on the size of the files being
copied, this may take a couple of minutes.
l. When all of the files have been copied, the message “Finishing copy...” is
displayed while the file system buffers are emptied. This message may
appear for a couple of minutes.
m. When the restore operation is complete, the message “Restore completed
successfully” is displayed before the menu display returns to normal.
TG8000 Declassification and Security Instructions 13

Tektronix TG8000 Specifications

General

Brand	Tektronix
Model	TG8000
Category	Portable Generator
Language	English