Introduction
Tel-Atomic's new pocket size TeslaMeter 2000 is unique for the features offered. The Sensor
will measure axial or transverse magnetic fields up to 2000 mT, and can be set for Auto- range.
However, if one of the 3 manual ranges is selected, an analog output of 2.5 volts for FSD of each
range is possible, making it easy to use with a computer interface.
With the 4 ½ Digit LCD readout you can use the sensor as a stand-alone Magnetic field meter.
In addition, the sensor is provided with a USB digital input/output so you can connect it directly
to your computer.
An EEPROM inside the probe has been programmed for temperature compensation of non-
linearity error. Following a patented method, the unit removes temperature effects of magnetic
sensitivity, resistive residual voltage and also all magneto resistive effects. If necessary, the unit
can be re-calibrated easily with the help of the zero-gauss chamber.
The TeslaMeter 2000 comes with complete operating instructions, an axial and transverse probe,
the zero-gauss chamber as well as an external power supply.
Specifications
Measurement Ranges: ±19.999 mT, 1µT resolution
±1999.99 mT, 10 μT resolution
±1999.9 mT, 100μT resolution
Measured value mode: Constant Magnetic Field [mT]
Alternating Magnetic Field up to 500Hz in RMS [mT]
Magnetic Field Sensor: Hall Effect GaAs type sensor
Measurement Probes: Axial and Radial,
12.5mm long,
100cm cable with 9 pin "D” type male connector
DC Range Accuracy: ± 0.05% on each range
AC Range Accuracy: ± 0.2% on each range
Resolution: .001mT
Range selection: Manual, Auto
Digital data format: ASCII data
[±XX,XXmT”CR””LF”], [±XXX,XmT”CR””LF”], [±XXXXmT”CR””LF”]
Analog output: ± 2.5V max. resolution 128 bit per ±2000mT
Measuring utilities: Zero the hall sensor with the "Zero Gauss Chamber”.
Set offset readout for the current field.
Non-Volatile memory for caching the "last used”
measurement range and mode.
User buttons: Power: on / off
Measurement mode: ac / dc
Measurement range: 2000mT, 200mT, 20mT, AUTO
Zeroing: readout offset / sensor zero
Power Off: Manual or Auto after 10 min.
Power On: Manual
Total Weight: 200g (including batteries)
Dimensions (HxWxD): 130mm x 75mm x 26mm
Display: 4 1/2 digit LCD
Readout frequency: 4 Hz
External power supply: 12V, 100mA, DC 2mm power jack
Supply: 4 x R3 (AAA) type cells
To Next Page
Loading...