complete graph of data since recording began. The F1 key is operative during both the collecting
of data as well as for displaying data after data collection has been stopped.
After pressing F1 and displaying all of the data you can “zoom” in on a special region of interest.
Press the SHIFT key and with the mouse choose the region of interest you want to examine.
Press the “R” key to return to the normal screen.
Press the stop button in the tool bar to terminate data collection.
Please note: Both the x and y axis are auto ranging.
Saving Data
If you choose to save data it will be automatically exported to your spreadsheet in a CSV or in a
TXT with TAB spaces format. You can open this data with the spreadsheet program for further
data analysis.
Recording a Second Run
To record a second set of data simply press start. The screen will clear and data recording will
begin again.
Manual Recording
If you want to manually record data click on the manual button on the tool bar. With the cursor
on the manual button each time the left mouse button is pressed, data will be recorded. You can
also record data by simply pressing the ENTER key. The x axis is now “points” instead of time.
To end data recording press stop.
Please note: Even though data is taken only when the manual button is selected the “Magnetic
Induction Screen” continues to update at the 1Hz rate.
Data is saved in the manual mode as described earlier.
Ranges
When the range button on the TeslaMeter 2000 is pressed the software will reflect this change.
Please note: If the TeslaMeter 2000 is on, for example, the 200 mT range and the magnetic field
exceeds this level “FULL” will appear on the LED screen. However, the software can still
continue to collect data up to about a 50% over range.
To Next Page
Loading...