To Next PageTo Next Page
Need help?Do you have a question about the Telaire Ventostat 8000 Series and is the answer not in the manual?
Steps for installing the sensor on units without a display.
Steps for installing the sensor on units with a display.
Instructions for installing Ventostat products inside return air ductwork.
Steps for installing the pitot tube assembly for specific models.
Specifies the CO2 measurement ranges for different models.
Details the accuracy specifications for CO2 measurements.
Lists the voltage and frequency requirements for operation.
Explains the automatic self-calibration feature.
Details analog output types and specifications.
General| Model | Ventostat 8000 Series |
|---|---|
| Type | Controller |
| Sensor Type | Non-dispersive Infrared (NDIR) |
| Gas Measured | Carbon Dioxide (CO2) |
| Output | 0-10 VDC or 4-20 mA |
| Enclosure Rating | NEMA 1 |
| CO2 Measurement Range | 0-2000 ppm |
| Operating Temperature | 0 to 50°C |
| Storage Temperature | -20 to 70 °C |
| Operating Humidity | 0 to 95% RH, non-condensing |
| Power Supply | 24 VAC/VDC ±10% |
| Output Signal | 0-10 VDC, 4-20 mA (analog) |
| Response Time | <2 minutes |
| Weight | 0.5 lbs |
| Accuracy | ±30 ppm ±3% of reading |
| Accuracy CO2 | ±30 ppm ±3% of reading |
