GB
33
TRANSMITTER TECHNICAL DATA
V
mA
MHz
W
°C
Battery and power supply type *
Consumption in the transmitting mode
Frequency
Duty cycle class
Modulation
Radiated power
Operating temperature
Number of combinations
* Caution: lithium batteries. Danger if the polarity is reversed. Replace the
battery with one having identical characteristics. Dispose of the batteries as
recommended by the manufacturer.
For correct, easy programming, it is essential that the following instructions
are followed to the letter.
1. Preliminary operations
-
Connect an antenna tuned to the antenna terminal on the receiver.
Alternatively, diminishing the receiver specifications, a piece of wire
approx. 20 cm long may be connected
-
Once the receiver has been connected to the control unit or the neces-
sary connections onto the terminal board have been completed, switch
on.
STANDARD PROGRAMMING
3 (CR2032)
20
433,920
2
< 40KHz
250
-20+55
2
66
-
As soon as the receiver is powered it carries out an internal test shown by the
led (indicator light) L1 coming on briefly followed by L2 for 3 seconds.
2. Self-memorisation
- Upon pressing key P1 for an instant the relative
led will blink 5 times.
- Within this period of time, transmit with the
radio control required for use.
1
P1L1
FSK
GB
33
TRANSMITTER TECHNICAL DATA
V
mA
MHz
W
°C
Battery and power supply type *
Consumption in the transmitting mode
Frequency
Duty cycle class
Modulation
Radiated power
Operating temperature
Number of combinations
* Caution: lithium batteries. Danger if the polarity is reversed. Replace the
battery with one having identical characteristics. Dispose of the batteries as
recommended by the manufacturer.
For correct, easy programming, it is essential that the following instructions
are followed to the letter.
1. Preliminary operations
-
Connect an antenna tuned to the antenna terminal on the receiver.
Alternatively, diminishing the receiver specifications, a piece of wire
approx. 20 cm long may be connected
-
Once the receiver has been connected to the control unit or the neces-
sary connections onto the terminal board have been completed, switch
on.
STANDARD PROGRAMMING
3 (CR2032)
20
433,920
2
< 40KHz
250
-20+55
2
66
-
As soon as the receiver is powered it carries out an internal test shown by the
led (indicator light) L1 coming on briefly followed by L2 for 3 seconds.
2. Self-memorisation
- Upon pressing key P1 for an instant the relative
led will blink 5 times.
- Within this period of time, transmit with the
radio control required for use.
1
P1L1
FSK
Via Soldati, 14 -
Telefono 0422 80 76 45 - Fax 0422 80 73 54
E-mail: stampa@marpress.net - www.marpress.net
31040 SALGAREDA (TV)
STAMPA DIGITALE
Manuali / fogli istruzione
Listini prezzi / Presentazioni
Volantini / Giornaletti
Giornaletti / Depliant
Libri a bassa tiratura
ecc...
Via Soldati, 14 -
Tel ef on o 0422 80 76 45 - Fax0422807354
E-mail: stampa@marpress.net - www.marpress.net
31040 SALGAREDA (TV)
STAMPA DIGITALE
Comunicazione per:
alle ore del
Ha telefonato
È passato
Richiamare Sig.ra/Sig.
al numero tel.
MESSAGGIO
To Next Page
Loading...
