For correct, easy programming, it is essential that the following instruc-
tions are followed to the letter.
1.Preliminary operations
- Connect an antenna tuned to 433 MHz to the antenna terminal on the
receiver. Alternatively, diminishing the receiver specifications, a piece
of wire approx. 20 cm long may be connected
- Once the receiver has been connected to the control unit or the nec-
essary connections onto the terminal board have been completed,
switch on.
- As soon as the receiver is powered, it carries out an internal test,
shown by LED L2 coming on for 3 seconds.
2.Self-memorisation
- Upon pressing key P1 for an instant the relative led will blink 5 times.
- Within this period of time, transmit with the
radio control required for use.
- Fixed indicator lights lasting about 3 seconds
indicate that the code has been successfully
stored.
GB
V 12
MHz 433,920
KHz +/-200
?
W 100
°C -20+60
1.048.576
TRANSMITTER TECHNICAL DATA u.m.
Battery power supply type GP 23A
Frequency
Stability
Radiated power
Operating temperature
Number of combinations
STANDARD PROGRAMMING
To Next Page
Loading...