Teledyne Cetac Technologies ASX-280

Need help?

Do you have a question about the Teledyne Cetac Technologies ASX-280 and is the answer not in the manual?

Summary

Installing the Autosampler

Mounting the Z-Drive

Connecting to the Analytical Instrument’s Sample Port

How to connect the autosampler's sample tubing to the analytical instrument.

Connecting the Autosampler to the Host Computer

Establishing communication between the autosampler and the host computer.

Verifying Installation (IQ and OQ)

Installation Qualification (IQ)

Procedure to verify correct shipping, unpacking, and installation of the autosampler.

Communication Test

X;Y;Z Movement and Alignment Test

Testing the probe's movement and alignment for proper sample uptake.

Operational Qualification (OQ)

Verifying system performance against experimental method requirements.

Using the Autosampler

Starting the Autosampler

Procedure for initiating an autosampler sequence run.

Shutting Down the Autosampler

Maintaining the Autosampler

Cleaning the Sample Probe

Replacing the Z-Drive

Troubleshooting the Autosampler

Power System Problems

Communications Interface Problems

Troubleshooting issues with serial or USB connections to the host computer.

Z-Drive Problems

Diagnosing and fixing problems related to the Z-drive assembly.

Returning the Product to CETAC for Service

Safety and Regulatory Information

Safety Notices

General safety warnings and precautions for operating the equipment.

Mechanical Hazards

Operating Environment Warnings