Changing Number of Pockets
See figure 3-B
Indexers are convertable between 4 and 6 pockets. The Switch Cover must be
removed. Move the junmper on J4 to the desired number of pockets. All the
jumpers on J4 must be across etheir “4pkt” or “6pkt”. The switch on the back
panel of the controller must match the jumpers on the Indexer Iso PCB.
Control PCB
See figure 3-C
The model 376 has C1 installed and not S1.
The model 379 has S1 installed and not C1. S1 is used to select the end of the
banana pocket, an in figure 4-1. The number 2 position is defalt as shipped from
the factory. For banana Pocket setup see operation chapter.
INSTALLATION 3-3
Telemark 376/379 Crucible Indexer
Figure 3-B
Change
Number of
Pockets
To Next Page
Loading...