4
OPERATION
General Operation
Before using, first determine which materials are to be placed in the crucibles.
To set up the indexer, First rotate the switch to pocket one on the indexer
controller. Unplug power to the indexer to prevent accidental injuries. Then undo
the set screws on the coupler or drive gear. Rotate the crucible till the number one
pocket is lined up with the front of the source.
With the pocket lined up and the controller on pocket one, tighten down the set
screws on the couplers. Plug in power to the indexer, check to see that it is
indexing properly.
To use the desired pocket simply rotate the switch to that pocket. The light will
light-up when the selected pocket is reached.
The indexer is ruggedly designed and built, and should last a long time between
adjustments.
Model 379 Modes
The Model 379 Indexer has three modes of operation:
1 Normal - In this mode it operates like a model 376.
OPERATION 4-1
Telemark 376/379 Crucible Indexer
To Next Page
Loading...