Page 15 of 15
TVP Manual (full) March 2007 CE rev 03.doc
Enter return and the message following will appear if a connection has successfully been
made.
Diagram 7
Entering a query with a “? Return” will give the following screen
Diagram 8
Note
All commands must be executed as lower case characters followed by return. All commands
apart from the specialised calibration routine follow a three-character format.
W2o
Turning the comms link on and allows both data logging (verbose mode) and control of the
TVP.
W2f
Turns the link off in this mode so only data logging is permitted
To Next Page
Loading...