Telemic HouseControl E+ - 3 Installation; Opening Unit Cover; Hce+ from Inside; Connectors

4 HouseControl E+ Installation Manual
3. INSTALLATION
3.1 Opening Unit’s Cover
There is a small curved indentation on the top of the central unit.
Place your hand into the indentation and carefully detach the
cover.
The cover must be fastened with screws after installation is
complete. The screws are included in the package.
3.2 HCE+ from Inside
1. Heater/Aircon relay (see 3.3)
2. Ext relay (see 3.3)
3. Camera and data connector
4. Inputs for temperature sensors, siren, magnetic door
switches, moisture sensor, motion sensor, smoke detector,
security keypad and 12V power supply (see 3.3)
5. Cable holder
6. SIM card slot
7. Power switch
8. Tamper switch
9. Manual heating switch (red light is on when manual control
is used)
10. Door security on/off switch
3.3 Connectors
Do not use your fingers when inserting wires into the spring clips
– Relays may be damaged if you push your fingers against them.
1
2
3
4
5
6
7
8
9
10