Telephonics RDR-1600 - Page 3

81 pages

Save Page as PDF

To Next Page

To Previous Page

TM106601_(7/01) FMi

USE OR DISCLOSURE OF DATA CONTAINED ON THIS PAGE IS SUBJECT TO THE

RESTRICTION ON THE TITLE PAGE OF THIS DOCUMENT.

OMMAND

YSTEMS

IVISION

Maintain prescribed safe distance when standing

in front of radiating antenna.

Never expose eyes or any part of the body to an

unterminated wave guide.

CAUTION

Main Page

Default Chapter11
- Table of Contents11
Basic System Functions18
Chapter 1 . General Information18
Operational Modes19
Search Modes19
Weather Avoidance Modes19
Beacon Mode20
Dual Mode of Operation20
- Equipment Part Numbers and Descriptions20
RDR-1600 System Components20
CP-113 Unit Description22
CP-113 Function Select Switch22
CP-113 Mode Push Buttons23
- Additional Equipment Required for Complete Installation25
Additional Available Equipment25
Equipment Required but Not Supplied26
Leading Particulars27
RDR-1600 Radar System27
RT-1601 Receiver Transmitter29
DA-1203A Antenna Drive29
CP-113 Radar Control Panel33
Antennas33
DA-1203A Antenna Drive33
- Equipment Operation and Controls34
Operating Precautions34
License Requirements34
Figure 1.6-1. CP-113A Radar Control Panel35
Figure 1.6-2. CP-113K Radar Control Panel (with Brightness Pots)35
Operating Controls and Display Features35
CP-113 Operating Controls35
Figure 1.6-4. CP-113P Radar Control Panel36
Figure 1.6-5. Generic MFD Display (Radar Only Mode)39
MFD Display39
Operating Procedures39
General39
Turn on Procedure40
- Primary Mode Selection Procedures (WX, WXA, SR1, SR2, SR3, BCN)40
Range Selection Procedure41
Stabilization (STAB OFF) Control Procedure42
DO-172 Six-Pulse Beacon Interrogation45
- Target Alert Function48
Associated Publications48
Chapter 2 . Installiation49
- General49
- Installation Planning49
- Location of Equipment49
- Outline and Interconnect Drawings49
- Pre-Installation Check49
- Unpacking49
- Primary Power Requirements50
- Roll and Pitch Information50
- Assembly of Antenna Array and Antenna Drive Assembly Procedure51
- Installation of System Components51
- Radar Antenna51
- Post-Installation Check52
- Installation of CP-113 Radar Control Panel53
- Installation of RT-1601 Receiver Transmitter53
- Cabling54
- Installation of Waveguide and Cables54
- Waveguide54
- Post-Installation Check56
- Control Panel and MFD Display Check Procedure in Test Mode57
- Visual Inspection Procedure57
- Antenna Stabilization Check58
- Figure 2.7-2. Radar Control Panel60
- Antenna Checkout Aids61
- Pitch Calibration Check Procedure61
- Tilt Check Procedure61
- Roll Calibration Check Procedure62
- RF Operation Check Procedure63
- Interference Test Procedure64
- Preflight Check and Flight Check Procedures64
- Preflight Check Procedure64
- Single Indicators64
- Check Test Pattern67
- Flight Check Procedure67
- Multiple Displays67
- Check and Adjust Antenna Stabilization68
- Check Target Alert69
- Check Weather Alert Mode69
- Illustrations and Drawings70
- Testing Completed70
- Figure 2.9-1. Video Pattern, Level Flight71
- Figure 2.9-2. Video Pattern with Stab Error71
- Figure 2.9-4. Video Pattern, no Stabilization71
- Figure 2.9-5. RT-1601 Receiver Transmitter Outline Drawing74
- Figure 2.9-6. DA-1203A Antenna Drive Outline Drawing75
- Figure 2.9-7. CP-113 Radar Control Panel Outline Drawing76
- Figure 2.9-8. RDR-1600 System Wiring Diagram with Analog Gyros77
- Figure 2.9-9. RDR-1600 System Wiring Diagram with AHRS System78
- Figure 2.9-10. DA-1203A Antenna Mount Hole Pattern79

Other manuals for Telephonics RDR-1600

Pilot's Guide34 pages

Related product manuals

Telephonics RT-1601 RT

34 pages

Telephonics CP-113K

34 pages

Telephonics RDR-1600 - Page 3

Table of Contents

Other manuals for Telephonics RDR-1600

Related product manuals