Standard battery Ni-MH 3,5 AH Long life battery Ni-MH 6 AH
Figure 47.- Configuration of the switches according to the type of battery
4.- Switch the equipment off
5.- Disconnect the equipment from the mains
B) Another possibility is to substitute the battery for another with the same characteristics.
In this case, you only need to carry out steps 1 and 2 as described in the previous section.
Warning about battery changing
· When removing or introducing the batteries, make sure that the meter is switched off.
· If you remove the battery, when you put it back in again, make sure that it is connected
correctly.
· If you are using metal tools for the installation of the batteries, you must isolate them, as
they could cause a shortcircuit.
· Do not connect the positive terminal to the negative terminal of a battery with a metal
object, the battery could re-heat, emit hydrogen gas, undergo spillage, burn or explode.
· The user should use batteries provided by Televés, which are appropriate for this
equipment.
3.3.2.6.3.- Battery regeneration
The FSM500 disposes of a function which carries out a recycling of the batteries. This option
regenerates the batteries when the duration of the batteries has dropped considerably.
This process should only be carried out if the powering without supply from the mains
has been reduced drastically since a repeated use of this function can shorten the
battery life.
For the regenerating process to take place, it is necessary to exter
nally power the meter
continuously for 15 hours.
To start this process, the user must be inside this menu and then press . Another screen
appears which explains the process and by pressing again, the process begins. If any
Multimetter FSM 500 Ref. 5903
50
To Next Page
Loading...
Need help?
General
