What to do if there is no picture on my Televes Receiver?
If there's no picture on your Televes Receiver, first, ensure the receiver is powered on by pressing the power key on the RCU. Next, check that the HDMI and/or SCART cables are firmly connected. Finally, confirm that the cable from the antenna is securely connected to your receiver.
Why is there no sound on my Televes Receiver?
If you're experiencing no sound or low sound on your Televes Receiver, start by checking the volume levels on both your TV and the receiver, ensuring they are not set too low or muted. Also, make sure the SCART or HDMI cable is firmly connected.
How to fix a Televes Receiver remote that is not working?
If the RCU (remote control unit) for your Televes Receiver isn't working, check the battery status first. Then, make sure you are pointing the RCU directly at the receiver without any obstacles in the way.
What to do if Televes Receiver finds no channels after searching?
If your Televes Receiver displays a “No channels were found” message after completing the channel search, ensure your antenna is properly connected to your receiver. Also, verify that the cable from the LNB is connected to the receiver input connector and that the options selected in the “Setting antenna” menu correspond to your installation.
Why is the image pixelated on my Televes Receiver?
If the image on your Televes Receiver is broken and appears in blocks (pixelated), try connecting your receiver in the simplest way possible by directly connecting the antenna to your receiver to check if the signal strength is sufficient. Additionally, damaged cables and connectors can affect signal quality, so try changing them.
How to fix Televes Receiver when the front panel LED is off?
If the front panel LED on your Televes Receiver is off, make sure the adapter is plugged in and connected to the receiver.
What to do if my Televes Receiver doesn't work after moving to a new home?
If you've moved your Televes Receiver to a new home and can't watch digital channels, a new channel search may be required. The antenna might not be aiming at the same satellite. For more assistance with the installation, consult your installer.
Why is the front panel LED red on my Televes Receiver?
If the front panel LED on your Televes Receiver glows red, it indicates that the receiver is in stand-by mode. Press the power key on the remote control unit (RCU) to power on the receiver.
Why is the image distorted on my Televes Receiver?
If the image on your Televes Receiver appears distorted or moved sideways, the display format may be set to 4:3 while the program is broadcast in 16:9. Change the display format to “Letterbox” or “Pan & Scan” in the “Output Settings” menu.
Identifies and describes the connectors and indicators on the front of the receiver unit.
Identifies and describes the connectors on the rear of the receiver unit.
Guides the user through the process of physically connecting the receiver to a television set.
Allows customization of receiver behavior, such as banner display duration.
Configures video and audio output options, including HDMI, SCART, and aspect ratio.
Explains how to reset the receiver to its original factory default configuration.
To Next Page
General
