TeleWell TW-EAV510 - Page 26

26
NAT and Firewall:
Enabled
Wireless LAN:
SSID: TW-EAV510xxxx (xxxx is as four last digits of mac address)
Wlan Key: Please find from bottom label
Wlan Encryption: “WPA2-PSK”
LAN and WAN Port Addresses
The parameters of LAN and WAN ports are pre-set in the factory. The default values are
shown in the table.
LAN Port
WAN Port
IPv4 address
192.168.0.254
The RFC1483 Bridged IP LLC
function is enabled to
automatically get the WAN IP
address from the ISP
Subnet Mask
255.255.255.0
DHCP server function
Enabled
IP addresses for
distribution to PCs
100 IP addresses continuing from
192.168.0.100 through
192.168.0.199
Information from your ISP
Before configuring this device, you have to check with your ISP (Internet Service Provider)
to find out what kind of service is provided.
Gather the information as illustrated in the following table and keep it for reference.
PPPoE(RFC2516)
VPI/VCI, VC / LLC-based multiplexing, Username, Password,
Service Name, and Domain Name System (DNS) IP address (it can
be automatically assigned by your ISP when you connect or be set
manually).
DHCP Client
VPI/VCI, VC / LLC-based multiplexing, Domain Name System (DNS)
IP address (it can be automatically assigned by your ISP when you
connect or be set manually).
Pure Bridge
VPI/VCI, VC / LLC-based multiplexing to use Bridged Mode.