What to do if the output from the circuit board assembly of Telex Headsets is outside the range?
If the output from the circuit board assembly of your Telex Headset is outside the expected range, the suggested solution is to replace the circuit board assembly.
What to do if there is no output from boom microphone assembly of Telex Airman 850 Headsets?
If you are experiencing no output or unacceptable output from the boom microphone assembly of your Telex Headset, the suggested solution is to replace the boom assembly.
Details headband adjustability and gimbal mounting for wearer comfort.
Describes the noise-canceling electret microphone and its flexible boom.
Explains the ANR On/Off switch and volume Hi/Low switch.
Highlights cord protection, strain relief, and RFI/EMI shielding.
Details receiver type, impedance, and potential compatibility issues.
Specifies microphone element type, matching impedance, frequency response, and sensitivity.
Outlines Active Noise Reduction power source and attenuation levels.
Lists various plug types and cord lengths for different models.
Explains procedures for warranty and non-warranty repair services, including shipping.
To Next Page
General
