F01U275275 Rev. 01 1 09/2012
IP-1616/C-6200 Handset Option (Field Installation)
The IP-1616/C-6200 Handset Option allows the user to install a handset to the C-6200.
IP-1616/C-6200 Case Top
Observe the right side of the IP-1616/C-6200 case top to determine if there are handset mounting holes. Three black rubber plugs fill the
handset mounting holes. Older units require mounting holes to be drilled. For more information, see “IP-1616/C-6200 Drilling Instructions” if
holes are required.
To remove the unit’s case top, do the following:
1. Remove the screws attaching the top case to the unit.
2. With the unit’s left side facing forward, remove the top and place it to the right (back) of the unit.
3. Remove the rubber plugs from the case top. See Figure 1.
FIGURE 1. IP-1616/C-6200 Case Top with Rubber Plugs
To Next Page
Need help?
General
