Telex IP-1616 - User Manual

F01U275275 Rev. 01 1 09/2012
IP-1616/C-6200 Handset Option (Field Installation)
The IP-1616/C-6200 Handset Option allows the user to install a handset to the C-6200.
IP-1616/C-6200 Case Top
Observe the right side of the IP-1616/C-6200 case top to determine if there are handset mounting holes. Three black rubber plugs fill the
handset mounting holes. Older units require mounting holes to be drilled. For more information, see “IP-1616/C-6200 Drilling Instructions” if
holes are required.
To remove the unit’s case top, do the following:
1. Remove the screws attaching the top case to the unit.
2. With the unit’s left side facing forward, remove the top and place it to the right (back) of the unit.
3. Remove the rubber plugs from the case top. See Figure 1.
FIGURE 1. IP-1616/C-6200 Case Top with Rubber Plugs

Summary

IP-1616;C-6200 Handset Option Installation

Case Top Removal and Plug Extraction

Details removing the unit's case top and rubber plugs for access.

Option Kit Contents

Option Kit Parts Identification

Lists and identifies all parts included in the handset option kit for verification.

Internal Connections and Assembly

Cable Insertion into Case Top

Guides the user on inserting the cable through the case top into the unit.

Switch Lead Soldering Procedure

Details soldering the switch leads to specific pins (1 and 3) on the PCBA.

Component Assembly and Installation

Snap Switch and Hanger Assembly

Assembles the snap switch to the handset hanger and secures the nuts.

Hanger Return Spring Installation

Installs the hanger return spring onto standoffs inside the case top.

Final Assembly and Connections

PCBA Switch Cable Connection

Connects the switch cable to the PCBA at specified ports (J10 or J80).

Installation Completion and Adjustment

Final Case Top Replacement

Replaces the unit's case top after all internal connections and components are installed.

Hanger Switch Adjustment and Handset Placement

Adjusts the hanger switch and connects the handset.

Handset Mounting Hole Drilling

IP-1616;C-6200 Drilling Instructions

Provides instructions and details for drilling mounting holes in the case top.

Telex IP-1616 Specifications

General

Brand	Telex
Model	IP-1616
Category	Music Mixer
Language	English