Telguard ML Series User Manual

4G LTE INTErCoM
|
ML raNGE INSTALLATION GUIDE
Raising Standards
Safety Assured
4G LTE I/o Board CONNECTIONS
The 4G antenna is an external item that should be
installed in the most suitable position so that maximum
signal strength is obtained and is more than 200mm
from a human body.
This positioning should also allow for avoidance of any
likely vandalism as is able.
4G LTE PCB CONNECTIONS
INSTALLATION TIPS
!
A SITE SIGNAL NETWORK TEST IS TO BE UNDERTAKEN
BEFORE INSTALLATION
TGML_IG_ISSUE 1_07.19
in
www.telguard.co.uk/support
z
Use the positioning template for the siting of the mounting holes.
z
Ensure the unit is sealed to prevent water ingress.
z
Use electronic grade silicone sealant to seal around all rear entry holes.
z
Ensure antenna and power leads have a loop before entering the back
of the unit to prevent water ingress along the cable.
z
Use the black plastic gland M20 x 1.5mm, std electrical thread to
secure the power and aerial leads.
z
If drilling out the backbox or steel posts, no metal filings must be left in
the backbox. The speaker has a magnet and may attract metal filings.
Brush out the back box of all debris before screwing in the faceplate.
z
Do a 4G signal test with a 4G analyser to ensure installation of the
best sim card.
z
Ensure the unit is turned off before inserting/removing the SIM and
plugging in/unplugging the aerial.
z
LED status lights: Green OK LED is multi purpose, it shows correct
antenna connection, correct sim card installation and signal strength
(RSSI).
z
The blue LED is the network status LED.
z
Use the faceplate parking slot for ease of installation.
z
We strongly recommend the PIN Defaults are changed at the point
of installation.
z
For full installation manual visit www.telguard.co.uk/support

Telguard ML Series Specifications

General

Brand	Telguard
Model	ML Series
Category	Intercom System
Language	English

Summary

4G LTE I/O Board Connections

4G LTE PCB Connections

Installation Tips

Mounting and Sealing

Use positioning template, seal unit to prevent water ingress, and use silicone sealant around entry holes.

Cable Management

Ensure loop for antenna/power leads before entry and use gland for securing leads.

Backbox Preparation

Remove metal filings from backbox after drilling and brush out debris before fitting faceplate.

Signal and SIM Card Installation

Perform 4G signal test and ensure unit is off before SIM/aerial insertion/removal.

LED Status Indicators

Understand Green OK LED for connection/SIM/RSSI and Blue LED for network status.

Installation Aids and Configuration

Utilize faceplate parking slot and change PIN defaults at installation.

External Antenna Placement

Position external 4G antenna for maximum signal, >200mm from body, and avoid vandalism.

Support Resources

Access full installation manual at www.telguard.co.uk/support.

GSM One App Guide

Select Device

Choose an existing device or add a new one in the application.

Set Up Telephone Numbers

Configure phone numbers for call buttons and add new contacts.

Manage PIN Codes

Add, edit, or delete keypad PIN codes for access.

Configure Incoming Calls

Manage authorized caller numbers for specific actions.

Rename Relays

Assign custom names to device relays for easier identification.

Change PIN

Modify the existing PIN for the device.

Manage Authorized Calls

Authorize specific numbers to trigger relays or actions.

Rename Relays (App)

Rename device relays directly from the application interface.

Programming Guides

Programming App GSM One

Details on programming common settings and features via the mobile application.

SMS Short Command Programming Guide

Instructions for advanced programming using SMS commands.