T
T
G
G
-
-
1
1
E
E
x
x
p
p
r
r
e
e
s
s
s
s
Q
Q
u
u
i
i
c
c
k
k
I
I
n
n
s
s
t
t
a
a
l
l
l
l
G
G
u
u
i
i
d
d
e
e
Programming Codes
To Program the TG-1 Express:
1. After the TG-1 Express is initialized, connect a POTS phone to the RJ-45 jack
or lineman’s butt set to the tip and ring turrets.
2. Take the POTS phone off hook or put the butt set in talk mode. You should
hear dial tone.
3. Dial ###*, and you should hear one beep.
4. Dial #*, and you should hear one beep.
5. Dial the POTS command number 8XX; you should hear one beep.
6. Enter the command data; you should hear 2 beeps.
7. After the last POTS command, dial * and listen for 2 beeps. Then hang up to
terminate the POTS programming session.
Register for Telguard Service
There are four ways to register the Telguard unit:
1. register online at www.telguardonline.com,
2. send the electronic registration form at
www.telular.com/telguard,
3. email the completed registration form to
cellservice@telular.com, or
4. fax the completed registration form to 678-945-1651.
Connect Dialer and Power to the TG-1 Express
Connect the alarm panel’s dialer to the RJ-45 jack on the TG-1 Express.
If using the Single Line Interface Cable (SLIC) for power, connect the
RJ-45 cable’s orange wire to the alarm panel’s ground and its blue
wire to the panel’s auxiliary power,. If using the terminal block,
connect pins 4 and 5 to the panel’s ground and power.
Continued…
56042601
Mem
Loc.
Field Setting (default indicated in bold)
851
STC Relay
Output
Reporting
Normally
Closed
Enter the SUM TOTAL of the events that you wish
to trip the STC relay by ADDING the
corresponding values:
00 = STC Relay Output Not Used
01 = LPF 08 = NSC
16 = RFC 32 = DTF
57 = ALL
852
STC Trip
Delay for
NSC
1=30 seconds, 2=60 seconds
3=3 minutes 4=10 minutes
5=20 minutes 6=30 minutes
7=45 minutes 8=60 minutes
9=24 hours
858 STC History
0 = terminate STC history display mode
1 = start STC history display mode
2 = clear STC history
868
PPF Delay
Timer
0 = disabled, 1 = 10 seconds, 2 = 20 seconds, …
15 = 150 seconds
873
Trip Input
Reporting
0 = no report
1 = report trip
874
Trip Input
Restoral
Reporting
0 = no report
1 = report restoral
875
Trip Input
Swinger
Function
0 = swinger function disabled
1 = swinger function enabled
899 Factory Default Unit
To Next Page
Need help?
General
