Telit Wireless Solutions ME310G1 - Page 65

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev.4 Page 65 of 545 2020-04-15
256
PDP unsuccessful activation cause wrong APN
257
PDP unsuccessful activation cause unknown PDP address or type
258
PDP unsuccessful activation cause service not supported
259
PDP unsuccessful activation cause QOS not accepted
260
PDP unsuccessful activation cause socket error
If none of the previous conditions has occurred since power up, then <code>=0 is
reported (i.e. No error, see table above)
AT#CEER=?
Test command returns OK result code.