Telkom EasiTouch 405 - Mounting the Phone; Setting the Telephone

7
3.
4. Plug the other end of the coil cord into the handset
socket.
Plug one end of the coil cord into the handset socket
at the back of the base.
6.6 Setting the telephone
There are 4 setting modes for setting the telephone.
These are:
SET 1: Date and Time (YY, MM, DD, Hr and Min)
SET 2: Access Code
SET 3: Flash Default setting 3 (110 mS)
SET 4: LCD Default setting 3
NOTE: The programming sequence of each facility and the
method of access to the SET mode follows the same procedure
as to setting the Year, Time and Date sequence which are
detailed below for clarity.
°
6.5 Mounting the phone
You can mount your telephone directly against a wall, or place it
on a shelf, desk or table.
The unit can be mounted to any wall surface using two self-
tapping screws (not supplied).
1. Drill two holes in the wall 67mm horizontally apart.
2. Insert wall plugs into each hole.
3. Then thread a screw into each hole, letting the heads
extend about 5mm from the wall. Position the base
over the two screw heads and push downward.
4. Slide out the handset hook on the base, rotate it 180
and replace it. The handset will rest on the hook when
wall mounted.