TY Instructions 2 3/20/12
TY Calibration Instructions for the new $50CAD Bill
You will need (10) x New $50 bills to complete this task.
1. While in the count screen, press the MENU key. This takes you to the “Menu” screen.
2. Ensure ‘Options’ is highlighted and press the ENTER key.
This takes you to the ‘Options’ screen.
3. Using the BILLS key, select ’Supervisor’ and press ENTER.
4. This takes you to the ’PIN Number’ screen, press the following keys in the order shown below:
ON-OFF ENTER $ ENTER.
This takes you to the ’Supervisor’ screen.
5. Ensure ’Setup/Calibrate’ is highlighted and press ENTER.
6. Ensure ’BILLS’ is highlighted and press ENTER.
You will now be in the screen entitled “Press WRAP for Setup”.
7. Using the BILLS key scroll and highlight ‘$50N’.
8. With ‘$50N’ highlighted press the MENU key to change the X to a .
9. With ’$50N’ highlighted press the WRAP key.
This takes you to ‘Calibrate Bills’ screen.
10. Now press the ENTER key.
This takes you to ‘Calibrate $50N’ screen.
11. The TY will now display ‘Put 10 loose Bills on hod and press ENTER’. Place the 10 new $50 bills on
to the hod, and then press ENTER.
12. The screen will now display ‘Add another 5 to 10’. Instead remove the bills from the hod.
13. Use the BILLS key to scroll and highlight ‘Save new weight’ and then press ENTER.
14. Press END repeatedly to return to the Count screen. Your TY is now setup for the $50N.
If you require assistance, please call the Tellermate Help Desk:
1-800-TELMATE
To Next Page
Loading...