Telstar MP50 - Product Usage and Operation; Charging and Initial Setup; Powering Up and Viewing Media

CHARGING THE PROJECTOR
The Projector is charged using the included AC Adapter.1.
The LED Indicator Light will illuminate Red to indicate the Projector is 2.
currently charging and then revert to Green when the Projector is fully
charged.
Important: Fully charge the Projector internal battery before rst use
(approximately 3 to 5 hours). The approximate run-time is 2 hours.
3. A low battery icon will show on the screen when the Projector battery is 3.
low. Use the included AC Adapter to charge your Projector. If the battery is
too low, the projector will automatically shut o.
SET UP
Connect one end of the AC adapter to the Projector 12V port and plug the 1.
other end into an electrical outlet.
Connect the HDMI cable (included) to the HDMI port and the other end to 2.
your device.
Note: You may need an adapter to connect your device to the HDMI cable.
Important! Apple® devices require an Apple Digital AV Adapter (sold separately) for HDMI
use. For all other devices, check the manufacturer’s instructions. Additional adapter specic
to your device may be required (e.g. Micro/Mini HDMI).
Connect a speaker to the 3.5mm audio out jack, if desired.3.
POWERING UP AND VIEWING MEDIA
Power on the Projector by sliding the Power Switch to on.1.
Touch the Circle Mode area on the top of the Projector, the screenwill then 2.
show you a choice of two modes, “Standard” for video and “Presentation” for
text-based media. Select your preference by touching the Mode area on the
top of the Projector while your choice is highlighted.
Choose the media you would like to view from the menu on your device and 3.
play it as you normally would.
The Projector can display media just about anywhere! However, for the best 4.
quality, we suggest you nd a light colored wall (preferably smooth and
white) and place the Projector with its lens facing the location. The Projector
can show media up to 60”, just move the projector towards and away from
the wall to adjust the size of the picture. Dimming room lights will also add
to viewing quality.
Note: If you are using one of the following device’s, you will see your device’s
screen displaying (mirroring) on the wall.
iPad (3rd generation)•
iPad 2•
Apple laptops with display port to HDMI adapter•
PC laptop with type A HDMI port•
11 12