EasyManua.ls Logo

Telstra T86 - Device Setup and Battery; Install a Micro SD Card; Battery Warnings; Charge Your Battery

Telstra T86
60 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
INSTALL A MICRO SD CARD
A microSD card can be installed or removed while the phone is turned on. You
need to unmount the microSD card before removing it. The device supports
microSD(HC) cards up to 128GB. Insert into the SIM tray as shown above.
Battery Warnings
Do not disassemble the device. The battery is non user replaceable.
Do not dispose of the device in a fire, the battery may explode.
Only use genuine chargers and accessories.
SWITCH YOUR DEVICE ON OR OFF, CHARGE YOUR BATTERY
Press and hold the Power Key to turn on your phone.
To turn it off, press and hold the Power Key to open the options menu.
Check the correct orientation of the lead, then insert the charger lead
Do not force the connector into the charger jack.
Connect the charger to a standard AC wall outlet.
Disconnect the charger when the battery is fully charged.
If the phone is on, you’ll see the charging icon / on the status bar.
If the battery is low, there will be a pop-up message on the screen. As
you charge your phone, the lock screen will tell you the battery level
each time you wake up your phone.

Related product manuals