What to do if my Tempest Leader SMOKE 5 appears dead?
If your Tempest Fog Machine appears dead, there are a couple of things you can check: * First, the mains fuse may have blown, so replace the fuse. * Second, there may be no power at the AC cable inlet, so check the power cable and circuit breaker.
Why is my Tempest Fog Machine not producing fog?
If your Tempest Fog Machine is not producing fog when the control panel is set to CONTINUOUS or the fog button is pressed, it could be due to the following reasons: * The machine might not be at the correct operating temperature. Wait until the HEAT message is no longer shown. * The FOG option might be set to 0. Increase the setting.
What to do if the remote is not working with my Tempest Leader SMOKE 5?
If you're experiencing a loss of control from the remote with your Tempest Fog Machine, there may be a communication issue between the remote and the machine. Check the cable connection between the remote and the machine to ensure it is properly connected.
What to do if my Tempest Leader SMOKE 5's fog output is weak?
If the fog output of your Tempest Fog Machine is weak, the machine may require priming. To do this, power down the unit, make sure the fluid bottle is full, and check that the tube is fully inserted.
Why is my Tempest Leader SMOKE 5 producing wet fog?
If your Tempest Fog Machine is producing wet, greasy, non-uniform fog output, fluid drips or spits from the nozzle, or makes a very loud noise when firing, it could be due to incompatible fog fluid. Make sure to use approved fluid!
General safety guidelines to prevent electric shock, burns, fire, injury, and breathing problems.
Introduces the control interface and how to adjust fog output intensity.
Instructions for configuring continuous fog production and timer-based operation.
General| Type | Fog Machine |
|---|---|
| DMX | Yes |
| Tank Capacity | 5 Liter |
| Warm Up Time | 5 min |
| Fluid Type | Fog fluid |
| Heating Time | 5 min |
| Remote Control | Yes |
To Next Page
